So i just did an coolant change. Took out the intercooler and did the full flush. I have a few questions i am unsure of...
I first refilled the tank with just distilled water to get out as much of the old stuff as i could. I left the bleeder screw and cap off and did the bleeding process. Did i hurt anything by leaving these things off?
Next i drained again and made up the 50/50 mix. I filled it and it took about 1.75 gallons. Should i be concerned it did not take all 2 gallons?
I then bles the system again but this time with the bleeder screw on and the cap tight? Was this the propper way to bleed? With the cap on tight? After the bleeding process, i opened the cap and added a little more coolant. I was done after this.
Dod i hurt anything by first bleeding with the distilled water with the bleed screw and cap off? If i did let some air into the system, i am assuming the second bleed i did when i put the actual coolant in would have taken care of that? The DIY on here says to have the cap on.
I am at work for 5 hours now and when i come back out to my car i was gonna open the bleed screw and cap to let out any air and check the level. Just to be safe, should i bleed it one more time? Is it okay to just randomly bleed it again?
If someone can answer these questions i would be so very grateful. Please excuse any typos as i am on my phone
I first refilled the tank with just distilled water to get out as much of the old stuff as i could. I left the bleeder screw and cap off and did the bleeding process. Did i hurt anything by leaving these things off?
Next i drained again and made up the 50/50 mix. I filled it and it took about 1.75 gallons. Should i be concerned it did not take all 2 gallons?
I then bles the system again but this time with the bleeder screw on and the cap tight? Was this the propper way to bleed? With the cap on tight? After the bleeding process, i opened the cap and added a little more coolant. I was done after this.
Dod i hurt anything by first bleeding with the distilled water with the bleed screw and cap off? If i did let some air into the system, i am assuming the second bleed i did when i put the actual coolant in would have taken care of that? The DIY on here says to have the cap on.
I am at work for 5 hours now and when i come back out to my car i was gonna open the bleed screw and cap to let out any air and check the level. Just to be safe, should i bleed it one more time? Is it okay to just randomly bleed it again?
If someone can answer these questions i would be so very grateful. Please excuse any typos as i am on my phone
Aucun commentaire:
Enregistrer un commentaire